www.seagate.com Products Support Partners News+Info Jobs Where to Buy Buy Online  
Disc Tape Software Software
 
  
Specifications for ST-39173N
This text file can be obtained by ftp. ASCII linedraw characters are used that display normally in textmode. Windows based environments can use the Letter Gothic Line TrueType font to display and print ASCII linedraw characters.
                         SEAGATE TECHNOLOGY, INC.
                              1-800-SEAGATE
                          http://www.seagate.com
                            (C)opyright 1997


ST-39173N Ultra-SCSI (Barracuda 9LP)

  +-----------+
  | REAR VIEW |  (ST-39173N)
  +-----------+

         50 pin I/O Cable Connection
         |
    J1+------------------------1+ /---------\    TOP (HDA)
     -+:::::::::::::::::::::::::+-| 0 0 0 0 |--
      +-------------------------+ +-5-G-G-12+    BOTTOM


  +-----------+
  | SIDE VIEW |  (ST-39173N)
  +-----------+

    FRONT    TOP (HDA)    J2  87654321              +-+
     OF ---------------------------------P-W-A------+J1
    DRIVE    BOTTOM           ::::::::              +-+
                              ||||||||
  Enable T-Res (N model only) +||||||+ Terminator Power|
   Start Delay (12 secs * ID) -+||||+- Terminator Power++
                  Motor Start --+||+-- Reserved         |
                Write Protect ---++--- Parity Disable   |
                                                        |
    +--------------------------------+                  |
    | Termination Power-source Table +------------------+
    +--------------------------------+-------------+
    |          -----....-----....-----PWA edge-----|
    |                       2 1       2 1     2 1  |
    | A Drive Supplies Bus   +-+     +-+           |
    | B Drive Supplies Own  °|°|     |°|°    +°-°+ |
    | C Bus Supplies Drive  °+°+     +°+°    +°-°+ |
    | A+B is valid           A         B       C   |
    +------------------------------Default---------+
    Note: ND drives do not have internal terminators or any other
          way of adding internal terminators to the drive; use
          external active termination if required.


  +------------+
  | FRONT VIEW |  (ST-39173N)
  +------------+
                                  +--+Reserved. Shipped with cover installed.
                                  |  +Do not remove. Do not install jumpers
                      TOP (HDA)  ++---+     1
     --P-W-A---------------------+::::|::::::+--
                 *    BOTTOM     +----+123456
                 |               J6    ||||||
            LED -+                     ||||||
                            Remote LED +||||+ ID 1
                           (pin-11 +5v) |||+- ID 2
                              Reserved -+++-- ID 4


                            ST-39173N


       FORMATTED CAPACITY (GB) __________________9.105
       AVERAGE SECTORS PER TRACK ________________237 rounded down
       ACTUATOR TYPE ____________________________ROTARY VOICE COIL
       TRACKS ___________________________________75,010
       CYLINDERS ________________________________7,501 user
       HEADS ______PHYSICAL______________________10
       DISCS (3.5 in) ___________________________5
       MEDIA TYPE _______________________________THIN FILM/MR
       RECORDING METHOD _________________________EPR4 16/17
       INTERNAL TRANSFER RATE (mbits/sec)________120 to 190
       EXTERNAL TRANSFER RATE (mbyte/sec) _______20 Sync
       SPINDLE SPEED (RPM) ______________________7,200
       AVERAGE LATENCY (mSEC) ___________________4.17
       BUFFER (/optional)________________________512/1024 KByte
         Read Look-Ahead, Adaptive,
         Multi-Segmented Cache
       INTERFACE ________________________________Ultra SCSI
              ASA II, SCAM level 2 (1 default)
       BYTES PER TRACK __________________________155,000 average
       SECTORS PER DRIVE ________________________17,783,240
       TPI (TRACKS PER INCH) ____________________8,250
       BPI (PEAK KBITS PER INCH) ________________180
       AVERAGE ACCESS (ms read/write)____________7.4/8.2
         Drive level with controller overhead
       SINGLE TRACK SEEK (ms read/write) ________1.1/1.4
       MAX FULL SEEK (ms read/write) ____________16/18
       MTBF (power-on hours) ____________________1,000,000
       SHOCK (G's, 11/2 ms):
                operating (Read/Write) __________5
                abnormal ________________________10
                nonoperating ____________________75/135
       ACOUSTICS (Bels typical, sound power) ____4.2
       POWER DISSIPATION (watts/BTUs) Active ____16.05/54.8
                                      Idle ______9.75/33.3
       POWER REQUIREMENTS: +12V START-UP (amps) _1.7
                           +12V TYPICAL (amps) __0.5 idle
                           +5V START-UP (amps) __1.2
                           +5V TYPICAL (amps) ___0.75 idle
                           IDLE (watts) _________10
       LANDING ZONE (cyl) _______________________AUTO PARK
       IBM AT DRIVE TYPE ________________________0 or NONE

       Physical:
                        Height (inches/mm):      1.0/25.4
                        Width  (inches/mm):     4.00/101.6
                        Depth  (inches/mm):     5.47/146
                        Weight    (lbs/kg):      1.3/0.589

Already low-level formatted at the factory with x spare sectors at
the end of each x cylinder region.  

ZBR = Zone Bit Recording = Variable sectors per track


Seagate reserves the right to change, without notice, product 
offerings or specifications. (04/15/98)


    
Products |Support |Partners |News + Info |Jobs |Where to Buy |Buy Online |Contact Us |Site Index

Copyright © 2001, Seagate Technology | Privacy Policy | Legal